• Infinity Meter Manual
• Aem Infinity Manual
• Aem Infinity 506 Manual
• Aem Infinity User Guide
• Aem Infinity Instructions
• Aem Infinity 6

EnteraLite ® Infinity Operator’s Manual iv LIST OF WARNINGS AND CAUTIONS WARNINGS 4.

Welcome to AEMC ®. AEMC ® Instruments manufactures professional electrical, thermal and energy test and measurement instruments for the industrial, commercial, and utility marketplace. As a business of the Chauvin Arnoux ® group, our products are backed by over 125 years of experience in test and measurement instruments and encompass the latest international standards for quality and safety. Don't have an account? Some harness user manuals contain active hyperlinks that point to specific sections or even launch additional. Wires that carry high current must run in twisted pairs. An example of. AEM Infinity Harness Manuals.

Universal 8

45

© 2014 AEM Performance Electronics

Infinity

Pin

Hardware Ref.

Infinity Meter Manual

7100-XXXX-62

7101-XXXX-63

Function

SpecificationsRicoh Australia Pty. Ricoh aficio mp c2000 pcl6 user manual. 60 Stanley Street, Parnell, Auckland New Zealand. 8 Rodborough Road, Frenchs Forest, NSW 2086. Phone: 02 8977 1111 Fax: 02 8977 1100 Web: ricoh.com.auRicoh New Zealand Pty.

Hardware Specification

Notes

C2-51

Coil 7

Coil 7

25 mA max source current

0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal.

C2-52

Coil 8

Coil 8

25 mA max source current

0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal.

C2-53

Coil 9*

Coil 9

25 mA max source current

0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal. *Pin not populated in 30-
3805 Univ ersal V8 Base harness.

Aem Infinity Manual

C2-54

Coil 10*

Coil 10

25 mA max source current

0–5V Falling edge f ire. DO NOT connect
directly to coil primary . Must use an
ignitor OR CDI that accepts a FALLING
edge f ire signal. *Pin not populated in 30-
3805 Univ ersal V8 Base harness.

C2-55

Highside Fuel Pump
Switch*

Fuel Pump

Highside switch, 0.7A max, Solid State
Relay , NO internal f ly back diode.

+12V High Side Driv e. Will prime f or 2
seconds at key on and activ ate if RPM >
0. *Pin not populated in 30-3805 Univ ersal
V8 Base harness.

C2-56

Not used

Not used

Not used

Not used

AEM Infinity Pin Numbering

View ed From Wire Side

Aem Infinity 506 Manual

ManualsAEM 30-71XX Infinity Stand-Alone Programmable Engine Mangement System Full Manual User Manual, 408 pages

Recognized languages:	English
Pages:	408
Size:	24.31 MB

Aem Infinity User Guide

Show table of contents

• Introduction
• Software
• Hardware
• Tuning Guide
  • Basic Tuning
    • Wizard Basic Setup
      • Injector Setup
      • Basic Sensor Setup
  • Advanced Tuning
    • Wizard Advanced Setup
      • Engine Protection
      • Input Function Assignments
        • Analog 0-5V & Modes
        • Switches
        • Speed & Frequency
        • Temps
        • Axis
      • Knock Setup
      • Rev Limit 2Step
      • Rev Limit 3Step
      • Traction Control
• EFI Components
• Fuel System Setup
• Wiring, Pinouts and Schematics
  • Wiring
    • Wire Harness Options
  • Example System Schematics
• Glossary of Terms

Read manual

Aem Infinity Instructions

Aem Infinity 6