• 5th Wheel Landing Gear Replacement
• Fifth Wheel Landing Gear Repair

• From lightweight to luxurious, Jayco fifth wheels break away from the ordinary without breaking the bank. From our well-equipped Eagle lineup to our luxurious Pinnacle models, Jayco takes fifth wheel comfort to a whole new level.
• Sep 14, 2018  Buy Lippert 119226 Fifth Wheel Landing Gear Manual Crank Handle: Engine & Chassis Parts - Amazon.com FREE DELIVERY possible on eligible purchases.
• 5th Wheel Landing Gear Owners Manual OTHER INFORMATION. Landing gear and Power Kit capacities and specifications are provided on page 2. Venture landing gear is lifetime lubricated and should never require maintenance. Heavy Duty 900.

TROUBLESHOOTING – CHECKING FOR BAD CYLINDER

1. Retract (close) the slideout (room) completely.
2. Loosen hose from “E” (extend) port on the manifold of the Power Unit.

WARNING!

Do not attempt to run room out with the “E” port hose loose.
The system will experience RAPID FLUID LOSS.

3. Plug opening on manifold to prevent drawing air into the system.
4. Energize the Power Unit to retract (close) room.
5. Continue to run the room in and watch for fluid flow from hose/port
“E”. Fluid flow greater than a few drops will indicate internal cylinder
leaking (bypassing of piston seal). If there is no fluid flow, reconnect
hose to “E” port and tighten.

WARNING!

Be sure to reconnect and tighten hose at the “E” port before
attempting to extend (open) the room or the system will
experience RAPID FLUID LOSS.

Contact qualified technician if there is excessive fluid flow. The cylinder should
not be repaired in the field.
Refill the Power Unit Reservoir as recommended on Page 10 of this manual.

Nov 05, 2012  I've got a 2009 Cedar Creek 5th wheel thats developed an issue with the landing gear. Basically, as i try to raise the trailer all i'm getting is a clicking sound from one of the gear assemblies. I can't tell if it's from the gear assembly attached to the landing leg or the gear assembly attached to the motor (power head). RV 5th wheel landing gear contains all the accessories as well as mounting options. Venture is well known manufacturer of RV landing gears and it’s accessories.

TROUBLESHOOTING – POWER UNIT

Before attempting to troubleshoot the Power Unit, make sure an adequate power

5th Wheel Landing Gear Replacement

source is available. The unit batteries should be fully charged or the unit should

be plugged into to A/C service with batteries installed. Do not attempt to

troubleshoot the Power Unit without assuring a full 12V DC charge. The

following tests require only a DC voltmeter (or DC test light) and a jumper lead.

Step 1 - Attach voltmeter (or test light) leads to the negative and positive

terminals on motor solenoid (See Fig. 7). Does the meter indicate 12V DC?

If YES, see Step 2; if NO see Step 3.

Step 2 - If YES, at the motor, check the incoming leads to 12V DC (if necessary,

2003 yamaha r6 service manual download. disconnect leads at wire splices). Does meter indicate 12V DC? If YES, Power

Unit needs to be replaced. The motor is not field serviceable. DO NOT

ATTEMPT TO REPAIR. If NO, Inspect all wires and connections between the

wall switch and the motor. Repair connections as necessary. Recheck as in

Fifth Wheel Landing Gear Repair

Step 1.

Step 3 - If NO, Inspect all connections between battery and solenoid. Inspect

30A Auto-reset Circuit Breaker (See Fig. 7 for location).

Recheck as above in Step 1.

Since there are no field serviceable parts in the motor of the Power Unit,

electrical troubleshooting and service is limited to replacing only those

components as previously outlined. Thorough inspection of wiring and

connections is the only other electrical service that can be performed.

23